9a.m. - 5p.m. est. Monday - Friday

1-877-650-4PHL (4745)

It's A New # with the Same Great Service!

WIRING DIAGRAMS

Below is how the PowerHouse Systems should be wired. Follow the diagrams and use proper wire and size to run the system. If you are extending the output leads of the run & guns you have to use 10awg. Input wires should never be extended but close to 12v cranking battery to provide good voltage to chargers. Failure to do as pictured can cause damage to the system and void all warranties. Damage that occurs, due to improper installation will not be the responsibility of PHL. Be sure to scroll down to see what system you need information on. We will show just the 36v Battery in trolling diagrams but if you use a 24v battery it will be the same procedure and wiring locations. 

 

Complete System without 28 volt regulator

(Includes 12v or 16v electronics battery)

 

 

16V ELECTRONICS  WITH BACKUP SYSTEM 

(REQUIRES BATTERY INSTALL KIT.  ALSO SHOWN WITH OPTIONAL FUSE BOX STYLE RIGGING INSTEAD OF WIRING HARNESSES BATTERY ONE STUD ON SWITCH IS 16V, BATTERY 2 STUD IS 12V AND OUTPUT STUD IS GOING TO THE ELECTRONICS)

 

 

 

 

28 VOLT SYSTEM WITHOUT BATTERY BACKUP

 

 

28 VOLT SYSTEM WITH BATTERY BACKUP